The instrument can store multiple solution configurations and staining programs. Accordingly, you must
select a solution configuration appropriate for the staining program you want to run and display the
selected configuration on the monitor screen before starting the program. This section explains how to
select and save a solution configuration that will be displayed on the monitor screen.
1. Touch the Menu key shown at the bottom right of the Stain Process Monitor screen.
2. Select Stain Process Menu from the Stain Process Menu, Utility Menu or Edit Menu, and then touch
the Solution Configuration Selection key.
3. Select and touch a desired solution configuration name under Solution Configuration List, and then
touch the Select key. For creating a new station configuration or editing an existing station
configuration, refer to "Setting a Solution Configuration" (P. 2-15).
"Selecting a Solution Configuration" If any of the following conditions applies to a solution station for
which a solution management option has been set, the solution management information will not be
transferred.
• The station position where solution management is performed changes when the solution
configuration changes.
• The solution at the station position where solution management is performed changes to a different
solution when the solution configuration changes.
• The management method for the station where solution management is performed changes when
the solution configuration changes.
If the solution used, station position (station number) and management method do not change after
the solution configuration is changed, the solution management information will be transferred.
Touch the Check Program key to check the staining programs that can be operated with the solution
configuration you have selected.
To check a given solution configuration, select the applicable solution configuration and touch the
View key to display the Solution Configuration View screen showing the applicable station
arrangement. You can also check the reservoir arrangement of the next configuration by touching the
Change View key at the bottom right. If the current solution configuration is appropriate, touch the
Select key. To check other solution configuration, touch the Exit key and select a desired solution
configuration again.
To Next Page
Loading...
Need help?
General
