Sakura Tissue-Tek Prisma Plus - Checking a Staining Program

Setting a Staining Program
2-33
Checking a Staining Program
This section explains the procedure to check if a given combination of solution configuration and staining
program is feasible.
1. Touch Menu at the bottom right of the Stain Process Monitor screen.
2. Select Program Check from the Edit Menu.
3. When the Program Check screen appears, select the solution configuration you want to check under
Solution Configuration List. Next, select the staining program you want to check under Program List.
4 After both the program and solution configuration have been selected, touch the Check key at the
bottom right. The "Program Check Result" screen appears.
5. This screen shows problems with the selected combination, if any. If necessary, change the staining
program and/or solution configuration by referring to the displayed check result to correct the
problems.