This section explains the procedures to pause and abort stain process. The abort operation can be
performed only after the pause operation.
● Pause operation
To pause staining process, touch the Pause key on the left of the Stain Process Monitor screen.
Touching the Pause key displays the pausing window. The arm will continue to move until a position
where it can stop safety, after which all staining runs will stop.
To resume stain touch the Resume key. Note that the pause operation may make it no longer possible
to complete the process by the scheduled end time. In this case, the scheduled end time must be
extended at the time of resumption by up to the period during which stain process has been paused.
● Abort operation
To cancel all or part of the current staining runs, touch the Pause key in the Stain Process Monitor
screen and then touch the Abort key. When the abort window appears, touch the All Runs key to
cancel all staining runs. To cancel certain staining runs, touch the applicable staining run numbers to
add a check mark to the "Selected" field of each staining run.
When the Abort key is touched, a confirmation screen appears and asks if you want to abort the
selected staining runs. Selecting Yes displays the abort completion window. Open the cover and
remove the aborted baskets. Once the baskets have been removed and the cover closed, the Exit key
is displayed. Touch this key to complete the abort operation.
To Next Page
Loading...
Need help?
General
