Standard Accessories/Options
1-23
* (1) Preinstalled inside the instrument.
(2) Pre-attached on the control panel screen.
(3) Of the four pieces, two are preinstalled on the instrument.
(4) Select either the standard solution reservoir set or small solution reservoir set.
(5) Pre-installed on each port.
Solution reservoir with handle
3-position reservoir tray
4-position reservoir tray
Special stain reservoir tray
Standard solution reservoir
Special stain solution reservoir
Lid, standard solution reservoir
Lid, small solution reservoir
Lid, special stain reservoir
10-slide basket load/unload adapter
20-slide basket load adapter
Heating solution reservoir
Hot air outlet panel, drying station
Station labels (Start, End)
Cap for covering water supply port
Water supply hose (faucet connection type)
Drain hose unit (38 mm x 2 m + cuffs)
Control panel protection sheet
Large lid, 3-position reservoir tray
Large lid, 4-position reservoir tray
3-position reservoir tray (2-phase stainless)
4-position reservoir tray (2-phase stainless)
Special stain reservoir tray (2-phase stainless)
Large lid, 3-position reservoir tray (2-phase stainless)
Large lid, 4-position reservoir tray (2-phase stainless)
Warranty registration card
Large lid, 3-position reservoir tray
Large lid, 4-position reservoir tray
Exhaust duct adapter, 38 mm dia.
Exhaust duct adapter, 75 mm dia.
Tissu-Tek Film link system
Large lid, 3-position reservoir tray (2-phase stainless)
Large lid, 4-position reservoir tray (2-phase stainless)
Tissu-Tek Glas-g2 link kit
Standard solution reservoir set
Small solution reservoir set
Special stain solution reservoir set
Special stain solution reservoir set (2-phase stainless)