To Next Page

To Previous Page

Data Printout/Record for Application Programs

(menu code 814 3 only)

For application programs, the reference data (parameters) can be included in the printout/record.

Auto. output of reference data (parameters) Code

Off * 7 1 1

Reference %/qty and reference weight 7 1 2

Reference weight only 7 1 3

lf the factory setting 7 1 1 is selected, printouts/records will not be Output.

To have data printed out, perform the following:

– Press the

or key to output the printout heading and reference data (the reference data will be stored at the same time)

– Press the

key to Output the printout heading and the first value

lf you input and store new references while a GLP/GMP record is being printed out, the new reference data will be output. lf

you enter different data before generation of a GLP/GMP record is started, the printout heading and the reference data will

automatically be printed once you press

. Then the measured value will be output.

– Output data by pressing the key

Choose one of the following:

– To end printout generation, press the key

(generation of a GLP/GMP printout also ends once a calibration or linearization Operation has been started)

– Then clear the reference data for the application programs by pressing the

key

– Clear the reference data for the application programs by pressing the key and the or key.

Then press the

key to end printout generation.

During data printout, the print symbol . appears in the display of the balance.

Sartorius mc1 User Manual

Questions and Answers: