SLT12 User Manual
132
[Insert]: Insert line metadata above the selected point.
[Delete]: Delete the selected line metadata.
Pile-by-pile table
Enter the interface of flat section design -> pile table, configure, view, and export the flat section mileage data.
Figure 11- 14
Figure 11- 15
[Setting]: You can set the starting mileage, ending mileage, mileage interval, offset distance, and staking method
for flat section mileage data export, click OK to apply successfully, and return to the stake-by-stake table
interface at the same time.
[Export]: Export the flat section data according to the parameter configuration set in the pile-by-pile export
setting interface.
To Next Page
Loading...
