SLT12 User Manual
143
Figure 12- 2
The parameters to be set are template name, angle, and layout method. (0,180) when the layout method is
orthogonal, and (0,180) when the layout method is oblique intersection vertical distance or oblique intersection
oblique distance.
4. In the pier template design interface, click the hover "+" button, and you can enter the feature point to add the
interface.
Figure 12- 3
If the feature point type is the cylinder, the parameters to be set are point name, vertical coordinate, horizontal
coordinate, and pile diameter. The pile diameter should be larger than 0.
To Next Page
Loading...
