94
[Notes]
1. By command <V>(Vertical print position) and <H>(Horizontal print position) print start position can be specified.
<V>100<H>200<2D10>***・・・・・・**
2. In case the both parameter d=e=00, aspect ration will be 1:2.
3. Parameters and data size being inconsistent may not be printed properly.
4. Higher Security Level will require larger numbers for parameter “d” or “e”.
5. Min. module width 01,02dot are not recommendable with a risk of lower scanner-readability.
6. Min. module height 01,02,03 dots are not recommendable with a risk of lower scanner-readability.
[Tips]
1. No sequential numbering is possible for PDF417.
2. No print position setting is possible by auto-CR.
3. 00H - FFH can be specified as print data.
4. Increase minimum module dimensions for better quality, as necessary.
5. Increase Security Level for better scanner-readability, as necessary.
6. Height of print image will differ for alphabet, numeric, and alpha-numeric data.
To Next Page
Loading...
