SATO WS4 Series - ESC+BX Datamatrix

164
2D Code
Available for
WS4 series
ESC+BX DataMatrix
ESC+BX
Hex code
ESC
BX
Parameter
<1B>16
<42>16<58>16
aabbccddeeefffghh
Default setting
None
Persistence of the
command
When printer is powered off
Set parameter will not be retained
Validity in a job
Becomes invalid after execution
Validity after a job
Becomes invalid after the job
[Function]
Specifies to print DataMatrix
[Format]
<BX>aabbccddeeefffghh
●Parameter
a [Format ID] = Valid range : 01 to 06
b [Error correction level] = 00 : (ECC000)
05 : (ECC050)
08 : (ECC080)
10 : (ECC100)
14 : (ECC140)
20 : (ECC200)
c [Cell width] = Valid range : 01 to 16 (dot/Cell)
d [Cell height] = Valid range : 01 to 16 (dot/Cell)
e [Number of cells per line] = Valid range : 008 to 148
000 : (auto-setup)
f [Number of cell lines] = Valid range : 008 to 148
000 : (auto-setting)
g [Mirror image] = 0 : Normal image (Normal print)
1 : Mirror image
h [Guide cell thickness] = Valid range : 01 to 15
Table of Format ID
[Notes]
1. When error correction level is set to 20, other three settings : Format ID, Mirror image, Guide cell thickness will be ignored.
2. Cell width, Cell height can be set to 01, 02, however may result in low scanner-read rate. 00 will cause an error.
3. When 000 is specified for “the number of cells per line”, or “number of cell lines”, the size of the code is auto-justified according to the
data to accommodate.
4. Guide cell thickness for normal type code is 01.
Error correction
Format ID
01
02
03
04
05
06
00（ECC000）
500
452
394
413
310
271
05（ECC050）
457
333
291
305
228
200
08（ECC080）
402
293
256
268
201
176
10（ECC100）
300
218
190
200
150
131
14（ECC140）
144
105
91
96
72
63
20 (ECC200)
Numeric
3116
Alphanumeric
2335
Binary (01H~FFH)
1556
* The above values are the maximum data volume which the 2D code can handle for a valid coding.
DataMatrix
Normal
Mirror