SATO WS4 Series - ESC+PC Register Printer Operation

186
System
Available for
WS4 series
ESC+PC Register Printer Operation
ESC+PC
Hex code
ESC
PC
Parameter
<1B>16
<50>16<43>16
1) [a, b, c, d, …y, z, a1], 2) [aa, b]
Default setting
See the next page
Persistence of the
command
When printer is powered off
Set Parameter will be retained
Validity in a job
Retained until next valid setting
Validity after a job
Retained until next valid setting
[Function]
Registers printer settings in EEPROM
[Format1]When all settings are newly registered
<PC>a,b,c,d,e,f,g,h,i1,i2,j,k,l,m,n,o,pppp,qqqq,rrrr,ssss,t,u,v,w,x,y,z,a1
●Parameter
a [Item No.] = F : All items
b・・・a1 [Setting details] = See table in next page for individual parameters
[Format2] When specific item are needed to be registered
<PC>aa,b
●Parameter
a [Item No.] = 1 to 27
b [Setting details] = See table in next page for individual Parameters
[Coding Example1] all items
<A>
<PC>F,,,2,,,,,A,4,,1,0,,1,1,3000,2400,,,,,,,,,1
<Z>
[Coding Example2] specific item
<A>
<PC>26,1
<Z>
[Notes]
1. The settings done by the command <PC> will persist after turning off the printer.
2. The entire or partial parameter entities is omissible by using commas. However, commas are not omissible.
Current valid setting will be applied to comma “,” position.
Register Printer Operation