SATO WS4 Series - 14 Memory Card Commands; ESC+CC Card Slot

204
14. Memory Card Commands
Memory Card
Available for
WS4 series
ESC+CC Card Slot
ESC+CC
HEX code
ESC
CC
Parameter
<1B>16
<43>16<43>16
a
Default setting
a=0
Persistence of
the command
When printer is powered off
Set parameter will not be retained
Validity in a job
Retained until next valid setting
Validity after a job
Retained until next valid setting
[Function]
Specifies the card slot number to be used.
[Format]
<CC>a
●Parameter
a [Slot number] = 0: RAM
1: Flash ROM
2: USB host
[Example]
<A>
<CC>1
<GI>H003003001FF000000~000000FF
<Z>
[Note]
1. This command must be used when command specification is need for a memory card.
Card Slot