SATO WS4 Series - ESC+A3 Base Reference Point

174
System
Available for
WS4 series
ESC+A3 Base Reference Point
ESC+A3
Hex code
ESC
A3
Parameter
<1B>16
<41>16<33>16
VabbbbHcdddd
Default setting
None
Persistence of the
command
When printer is powered off
Set parameter will not be retained
Validity in a job
Retained until next valid setting
Validity after a job
Retained until next valid setting
[Function]
Specifies a new base reference point
[Format]
<A3>VabbbbHcdddd
●Parameter
a Plus / Minus sign for vertical position correction = +, - (Omissible)
b Vertical position shift (dots) = 0 to 792 (dots)
c Plus / Minus sign for horizontal position correction (omissible) = +, - (Omissible)
d Horizontal position shift (dots) = 0 to 792 (dots)
[Coding Example]
<A>
<A3>V10H10
<Z>
V
H
指定前の基点
指定後の基点
[Notes]
1. The new position set outside printable area, will result in no printing.
2. The new position will be applied to all the label formats. Pay attention to it when you run multiple formats.
[Tips]
1. The values set by this command <A3> is not persistent after powering off the printer.
[Valid range]
Model
Horizontal offset (dots)
Vertical offset (dots)
WS408DT/TT
-792 to 792
-792 to 792
WS412DT/TT
-792 to 792
-792 to 792
Label feed direction
Base Reference Point
Original position
New position