SATO WS4 Series - 13 System Command; ESC+CS Print Speed

171
13. System Command
System
Available for
WS4 series
ESC+CS Print Speed
ESC+CS
Hex code
ESC
CS
Parameter
<1B>16
<43>16<53>16
a
Default setting
See table below
Persistence of
the command
When printer is powered off
Set parameter will not be retained
Validity in a job
Retained until next valid setting
Validity after a job
Retained until next valid setting
[Function]
Specifies print speed.
[Format]
<CS>a
●Parameter
a [Print speed] = see table below.
[Coding Example]
<A>
<CS>3
<Z>
[Note]
1. The setting by this command will not persist after powering off the printer. When the printer restarted, either the printer’ default value,
or original values set by the command <PG> will be valid.
[Tips]
1. Invalid range being selected will result in a command error and the setting will not be changed.
2. The default values are available by the operation of the printer side.
[Parameter default value and valid range]
Model
Default value
Parameter range
Parameter: Printer speed
WS408DT/TT
5
2, 3, 4, 5, 6
2 : 2 inch/sec (50mm/sec)
3 : 3 inch/sec (75mm/sec)
4 : 4 inch/sec (100mm/sec)
5 : 5 inch/sec (125mm/sec)
6 : 6 inch/sec (150mm/sec)
WS412DT/TT
4
2, 3, 4
Print Speed