SATO WS4 Series - ESC+2 D51 GS1 Datamatrix

133
2D Code
Available for
WS4 series
ESC+2D51 GS1 Datamatrix
ESC+2D51
Hex code
ESC
2D51
Parameter
<1B>16
<32>16<44>16<35>16<31>16
,aa,bb,ccc,ddd
Default setting
None
Persistence of
the command
When printer is powered off
Set parameter will not be retained
Validity in a job
Becomes invalid after execution
Validity after a job
Becomes invalid after the job
[Function]
Prints GS1 DataMatrix code.
[Format] (Setting portion)
<2D51>,aa,bb,ccc,ddd
●Parameter
a [Cell width] = Valid range : 01 to 16 dots
b [Cell height] = Valid range : 01 to 16 dots
c [Number of cell per line] = Valid range : 010 to 144
: 000 (Auto-setting)
d [Number of line per symbol] = Valid range : 008 to 144
: 000 (Auto-setting)
[Format] (Data portion)
<DN>mmmm,n~n
●Parameter
m Quantity of data = Valid range : 1 to 3116
n Print data = Data which consists of FNC1, AIs (Application Identifiers), and alphanemeric.
[Coding Example] Cell width : 3 dots Cell height : 3 dots
<A>
<V>100<H>200<2D51>,03,03,000,000
<DN>0024,<1B>
16
1(01)04977766654302(21)42345B
<Z>
[Notes]
1. In case any other parameters than GS1 specified, or parameters and quantity of data are not consistent with each other,
the symbol will not be printed correctly.
2. Make sure to leave 2mm margin of each side of the symbol for good scanner-readability.
3. The AIs (Application Identifiers) should be surrounded by blankets, for example “(01)”.
4. To check further GS1 rules, the GS1 org website is available: www.gs1.org/docs/barcodes/GS1_DataMatrix_Guideline.pdf
GS1 Datamatrix