SATO WS4 Series - ESC+~A Cut Number Unit

179
System
Available for
WS4 series
ESC+~A Cut Number Unit
ESC+~A
Hex code
ESC
~A
Parameter
<1B>16
<7E>16<41>16
aaaa
Default setting
aaaa=1
Persistence of
the command
When printer is powered off
Set parameter will not be retained
Validity in a job
Retained until next valid setting
Validity after a job
Set Parameter will be an default value for the next job<A>.
[Function]
Cuts labels at a specified interval in a print job.
[Format]
<~A>aaaa
●Parameter
a [Number of labels between each cut] = Qty range : 0 to 9999
[Coding Example]
<A>
<V>100<H>200<P>2<L>0202<XM>ABC
<~A>2
<Q>7
<Z>
(1) Normal (complete) cut mode
ABC
7 pcs
2 pcs
Left on printer
Complete
cut
Complete
cut
Complete
cut
Complete
cut
ABC
ABC
ABC
ABC
ABC
ABC
[Notes]
1. Valid only for cutter models.
2. If the parameter is not specified by this command <~A>, each label will be cut after being printed.
3. In case the parameter “a” is set to 0, no label will be cut.
4. Set this command before <Q>.
5. This command may not be used in combination with other cut commands<~>.
Label feed direction
Cut Number Unit