SATO WS4 Series - ESC+PH Print Method

191
System
Available for
WS4 series
ESC+PH Print Method
ESC+PH
Hex code
ESC
PH
Parameter
<1B>16
<50>16<48>16
a
Default setting
a=0
Persistence of the
command
When printer is powered off
Set parameter will not be retained
Validity in a job
Retained until next valid setting
Validity after a job
Retained until next valid setting
[Function]
Changes print method temporarily.
[Format]
<PH>a
●Parameter
a [Print method] = 0 : Thermal transfer
1 : Direct Thermal
[Coding Example]
<A>
<PH>0
<Z>
[Notes]
1. The setting by this command is normally not needed.
2. The setting is valid until the printer is powered off and printer’s internal setting becomes valid after rebooting.
Print Method