SATO WS4 Series - ESC+NC (EJ) Eject and Cut

178
System
Available for
WS4 series
ESC+NC (EJ) Eject and Cut
ESC+NC
Hex code
ESC
NC (EJ)
Parameter
<1B>16
<4E>16<43>16
None
Default setting
None
Persistence of
the command
When printer is powered off
Set Parameter will not be retained
Validity in a job
Becomes invalid after execution
Validity after a job
Becomes invalid after the job
[Function]
Cuts any printed labels that remain in the printer.
[Format]
<NC>
[Coding example]
<A>
<NC>
<Z>
[Notes]
1. Valid only for cutter models.
2. This command is used to cut the last label remaining in the printer.
3. This command should be used by differentiating between Start code<A> and Stop code<Z>.
4. This command <NC> may not be used in combination with other commands.
5. This command <NC> is valid while the printer is not working after printed and finished cutting operation.
[Tips]
1. This command is used to cut remaining label in printer after the commands <CT>0 or <~>0 is executed.
(1)
(3)
(4)
(5)
(2)
(1) Label stop position
A: Printed
B: Not printed
C: Not printed
D: Not printed
(2) Command received
(3) Label is fed to the cut position.
(4) Label is cut off.
(5) Label is back fed to the head position.
Feed direction
Eject and Cut
A
B
C
Cut position
Print head
A
B
C
D
B
C
D
B
C
D