SATO WS4 Series - ESC+&S Store Form Overlay

206
Memory Card
Available for
WS4 series
ESC+&S Store Form Overlay
ESC+&S
HEX code
ESC
&S
Parameter
<1B>16
<26>16<53>16
,aa(,bbbb,ccccc)
Default setting
None
Persistence of the
command
When printer is powered off
Set parameter will be retained
Validity in a job
Retained until next valid setting
Validity after a job
Retained until next valid setting
[Function]
Stores fixed print contents to memory card.
[Format]
<&S>,aa(,bbbb,ccccc)
● Parameter
a [Registration number] = Valid range: 1 to 99
[Coding example]
<A>
<V>100<H>100<XM>OMODEL
<CC>1
<&S>,1
<Z>
[Note]
1. The Card Slot <CC> command must be sent prior to this command.
2. Place the format to be stored between the Start Code <A> and the Stop Code <Z> commands.
3. Registration of identical store number is invalid.
4. The data of Graphics<G> and BMP File <GM> can be also stored.
5. This command allows up to 99 registries. Note that the capacity of registry may vary depending on the memory card to be used.
6. The data stored by this command are cleared by the Clear <*>R command.
[Valid Commands]
WS4 series
Font
<XU>
<XS>
<XM>
<XB>
<XL>
<U>
<S>
<M>
<WB>
<WL>
<OA>
<OB>
<RD>
<$=>
Barcode
<B>
<BC>
<BG>
<BI>
<BF>
<BP>
<D>
<D><d>
<BD>
<BT>
<BW>
2D code
<BK>
<BQ>
<BV>
<BX>
<2D10>
<2D12>
<2D20>
<2D30>
<2D31>
<2D50>
<2D51>
Modification
<WD>
<FW>
<(>
<RF>
Graphic
<G>
<GM>
<GP>
Store Form Overlay