SATO WS4 Series - ESC+2 D50 Datamatrix (ECC200)

131
2D Code
Available for
WS4 series
ESC+2D50 Datamatrix (ECC200)
ESC+2D50
Hex code
ESC
2D50
Parameter
<1B>16
<32>16<44>16<35>16<30>16
,aa,bb,ccc,ddd
Default setting
None
Persistence of
the command
When printer is powered off
Set parameter will not be retained
Validity in a job
Becomes invalid after execution
Validity after a job
Becomes invalid after the job
[Function]
Prints DataMatrix code (ECC200).
[Format] (Setting portion)
<2D50>,aa,bb,ccc,ddd
●Parameter
a [Cell width] = Valid range : 01 to 16 dots
b [Cell height] = Valid range : 01 to 16 dots
c [Number of cell per line] = Valid range : 000 (fixed)
d [Number of line per symbol] = Valid range : 000 (fixed)
[Format] (Data portion)
<DN>mmmm,n~n
●Parameter
m Quantity of data = Valid range : 1 to 3116
n Print data = Data
[Coding Example] Cell width : 3 dots Cell height : 3 dots
<A>
<V>100<H>200<2D50>,03,03,000,000
<DN>0010,0123456789
<Z>
[Notes]
1. In case any other parameters than above are specified, or parameters and quantity of data are not consistent with each other,
the symbol will not be printed correctly.
2. Make sure to leave 2mm margin of each side of the symbol for good scanner-readability.
3. To specify the code address [7EH], write [7EH, 7EH]. Quantity of data is [0002].
Data format
Quantity of data
Data format
Numeric
3116
Alphanumeric
2335
Binary (01H to FFH)
1556
Datamatrix (ECC200)