SATO WS4 Series - ESC+I2 Serial Interface

196
System
Available for
WS4 series
ESC+I2 Serial Interface
ESC+I2
Hex code
ESC
I2
Parameter
<1B>16
<49>16<32>16
abcde
Default setting
a=1,b=0,c=0,d=0,e=1
Persistence of
the command
When printer is powered off
Set parameter will be retained
Validity in a job
Becomes invalid after execution
Validity after a job
Becomes invalid after the job
[Function]
Specifies the setting of serial Interface.
[Format]
<I2>abcde
●Parameter
a [Baud rate] : 0 = 9600bps
1 = 19200bps
2 = 38400bps
b [Data bit] : 0 = 8bit
1 = 7bit
c [Parity] : 0 = No parity
1 = Odd
2 = Even
d [Stop bit] : 0 = 1bit
1 = 2bit
e [Control] : 0 = READY/BUSY control (Single item buffer)
1 = READY/BUSY control (Multi item buffer)
2 = XON/XOFF
3 = Driver protocol (STATUS4)
4 = STATUS3
[Coding Example]
<A>
<I2>10003
<Z>
[Notes]
1. The set parameter by this command will become valid after rebooting.
Serial Interface