SATO WS4 Series - ESC+&R Recall Form Overlay

208
Memory Card
Available for
WS4 series
ESC+&R Recall Form Overlay
ESC+&R
HEX code
ESC
&R
Parameter
<1B>16
<26>16<52>16
,aa
Default setting
None
Persistence of the
command
When printer is powered off
Set parameter will not be retained
Validity in a job
Becomes invalid after execution
Validity after a job
Becomes invalid after the job
[Function]
Recalls the tag or label image from memory card saved by command <&S>.
[Format]
<&R>,aa
● Parameter
a [Registration number] = 1 to 99
[Example]
<A>
<CC>1
<&R>,1
<Z>
[Note]
1. The Card Slot <CC> command must be sent prior to this command.
2. Several images stored under different registration numbers can be printed with this command.
3. If no registration number is specified, this command will be ignored.
4. A read/write error will occur if an unused registration number is specified.
5. If a tag or label image is stored without specifying a window size, the <V> and <H> position commands will be ignored, and the image will be
expanded from V1 and H1 (start position of drawing area).
6. The tag or label image can be moved by using the <V> and <H> position commands when it is stored along with a window size.
If it exceeds the printable area by being moved, the tag or label image will be truncated.
[Valid commands]
Print position
<V>
<H>
Recall Form Overlay