SATO WS4 Series - ESC+2 D31 QR Code (Model 1)

105
2D Code
Available for
WS4 series
ESC+2D31 QR Code (Model 1)
ESC+2D31
Hex code
ESC
2D31
Parameter
<1B>16
<32>16<44>16<33>16<31>16
,a,bb,c,d(,ee,ff,gg)
Default setting
None
Persistence of
the command
When printer is powered off
Set parameter will not be retained
Validity in a job
Becomes invalid after execution
Validity after a job
Becomes invalid after the job
[Function]
Specifies QR code (Model1)
[Format]
<2D31>,a,bb,c,d(,ee,ff,gg)
●Parameter
a Error correction level = L : 7％
M : 15％
Q : 25％
H : 30％
b Size of one side of cell = Valid range : 01 to 32 dots
c Data setting mode = 0 : Manual
1 : Auto
Note that two different data setting modes above are available.
d Concatenation mode = 0 : Normal mode
1 : Concatenation mode
In case concatenation mode is selected, the following settings are mandatory. If normal mode is selected, omit the settings below.
e Quantity of partitions by concatenation mode = Valid range : 01 to 16
(How many partitioned QR codes are concatenated.)
f Sequential number partitioned by concatenation = Valid range : 01 to 16
(Sequential numbering to each partitioned symbol)
g Concatenation parity data = Valid range : 00 to FF
(Parity data is a result of XOR calculation of entire data of QR Code expressed in Hexadecimal character.)
[Format] (Data portion)
<DS>k,n~n
<DN>mmmm,n~n
●Parameter
k Input character mode = 1 : Numeric mode
2 : Alphanumeric mode
3 : Kanji mode (ShiftJIS Kanji code)
This setting is only required when manual data setting is selected.
Use command <DN> for binary data input.
m Quantity of data = Valid range : 1 to 486
When auto data setting is selected, or binary data input is selected, Quantity of data shall be specified.
n Print data = Data
QR Code (Model 1)