SATO WS4 Series - ESC+Q Number of Pages

12
Control
Available for
WS4 series
ESC+Q Number of Pages
ESC+Q
Hex code
ESC
Q
Parameter
<1B>
16
<51>
16
aaaaaa
Default setting
aaaaaa=1
Persistence of
the command
When printer is powered off
Set parameter will not be retained
Validity in a job
Becomes invalid after execution
Validity after a job
Becomes invalid after the job
[Function]
Defines number of pages to be printed.
[Format]
<Q>aaaaaa
● Parameter
a [Number of pages] = Valid range : 1 - 999999
[Coding example] 2 pages to be print
<A>
<V>100<H>200<P>2<L>0202<OA>ABCD
<Q>2
<Z>
[Notes]
1. The data between start data transfer <A> and end data transfer <Z> is regarded as one page. <Q> defines how many pages of
the same content shall be printed out.
2. Command is put in before the end data transfer <Z> command.
[Important]
1. Print out of the same information will be done for pages specified. If the appearance of a serial number is set <F>, then this
number will be of consecutive order.
2. If specifying with a multi-cut <~>, the defined number of pages will be multiplied by cut number.
Number of Pages