SATO WS4 Series - ESC+WI IP Address Setup

201
System
Available for
WS4 series
ESC+WI IP Address Setup
ESC+WI
Hex code
ESC
WI
Parameter
<1B>16
<57>16<49>16
a
Default setting
a=1
Persistence of the
command
When printer is powered off
Set Parameter will be retained
Validity in a job
Becomes invalid after execution
Validity after a job
Becomes invalid after the job
[Function]
Specifies IP address setup method.
[Format]
<WI>a
●Parameter
a [IP address setup] = 0 : Manual setup
1 : DHCP
[Coding Example]
<A>
<WI>1
<Z>
[Notes]
1. Place this command between start code<A> and stop code<Z>.
2. This command may not be used in combination with other commands.
3. Setting can be printed on the factory test print.
4. The set parameter will become valid after rebooting.
5. Default setting of IP address is as follows:
IP address setup
1 (DHCP)
IP Address Setup