SATO WS4 Series - ESC+EP Print End Position

175
System
Available for
WS4 series
ESC+EP Print End Position
ESC+EP
Hex code
ESC
EP
Parameter
<1B>16
<45>16<50>16
None
Default setting
None
Persistence of the
command
When printer is powered off
Set Parameter will not be retained
Validity in a job
Becomes invalid after execution
Validity after a job
Becomes invalid after the job
[Function]
Specifies the label stop position in the sensor-disabled mode.
[Format]
<EP>
[Coding Example]
<A>
<A1>14240832
<Z>
<A>
<V>100<H>200<P>2<L>0202<OA>ABCD
<Q>2
<EP>
<Z>
Example)
( )の値は12dot/mm
【 】の値は24dot/mm
[Notes]
1. This command is valid when sensor is disabled.
2. Use this command in combination with size setting command <A1>.
ABCD
Label feed direction
When <EP> is not
specified
When <EP> is specified
1424 dots
30mm x 100mm
Label
100mm
800dot
(1200 dots)
178mm
1424 dots
(2136 dots)
30mm
240 dots
( 360 dots)
56mm
832 dots
(1248 dots)
1
1
Base reference point
FEED
The values in ( ) are for 12 dots/mm
Print End Position