SATO WS4 Series - ESC+WD Partial Copy

27
Modification
Available for
WS4 series
ESC+WD Partial Copy
ESC+WD
Hex code
ESC
WD
Parameter
<1B>
16
<57>
16
<44>
16
VaaaaHbbbbYccccXdddd
Default setting
None
Persistence of
the command
When printer is powered off
Set parameter will not be retained
Validity in a job
Becomes invalid after execution
Validity after a job
Becomes invalid after the job
[Function]
Copies data from one place to another destination.
[Format]
<WD>VaaaaHbbbbYccccXdddd
● Parameter
a [Vertical position of origin] = Valid range : Refer to the below
b [Horizontal position of origin] = Valid range : Refer to the below
c [Vertical dot number of origin] = Valid range : Refer to the below
d [Horizontal dot number of origin] = Valid range : Refer to the below
[Coding example] Vertical position of origin: 50, Horizontal position of origin: 50, Vertical dot number of origin: 200,
Horizontal dot number of origin: 400
<A>
<V>50<H>50<P>2<L>0202<XU>ABCD
<V>300<H>100<WD>V50H50Y200X400
<Q>2
<Z>
A B C D
A B C D
aaaa
bbbb
cccc
dddd
[Notes]
1. Specify the print position by vertical position <V> and horizontal position <H> before performing data copy <WD>.
2. Do not place the print position within the range of the origin.
3. If the print start position of copy area is outside of the printable area, it will not print due to a command error.
[Valid range]
Model
Valid range in dots
Horizontal position of origin
Horizontal dot number
Vertical position of origin
Vertical dot number
WS408DT/TT
1 to 832
1 to 7992
WS412DT/TT
1 to 1248
1 to 11988
Label feed direction
The dotted line indicates the copy range.
The actual print is limited to ABCD.
Partial Copy