SATO WS4 Series - Ethernet; Wireless LAN; Hardware; Transmission Speed;Modulation

89
Barcode
Available for
WS4 series
ESC+BL UPC-A Barcode (No HRI)
ESC+BL
Hex code
ESC
BL
Parameter
<1B>16
<42>16<4C>16
abbcccn~n
Default setting
None
Persistence of
the command
When printer is powered off
Set parameter will not be retained
Validity in a job
Becomes invalid after execution
Validity after a job
Becomes invalid after the job
[Function]
Specifies UPC-A Barcode with start/end bar in the same length with guard bar.
[Format]
<BL>abbcccn~n
●Parameter
a Barcode type = H : UPC-A(“H”Fixed)
b Narrow bar width = Valid range : 01 to 12 dots
c Barcode height = Valid range : 001 to 999 dots
n Print data = Data : 11 digits fixed
[Coding Example] Barcode type: UPC-A, Narrow bar width: 03, Barcode height: 120, Print data: 01234567890
<A>
<V>100<H>100
<BL>H0312001234567890
<Q>2
<Z>
[Notes]
1. This command supports UPC-A. Selecting barcode type other than “H” will result in a command error.
2. Refer to the following settings.
Barcode setting
Guard bar
HRI
Ratio
Yes
No
Fixed
3. If a parameter is specified out of the range, its behavior will not be supported.
4. When using command <D> to print UPC-A, the character bars will be all in the same length. The command <BL> will print the
start bar and end bar in the same length as that of guard bars
Print result of UPC-A by command <D> Print result of UPC-A by command <BL>
UPC-A Barcode
(No HRI)
Guard bar
Guard bar
Guard bar
Guard bar