SATO WS4 Series - ESC+~B Eject and Cut

180
System
Available for
WS4 series
ESC+~B Eject and Cut
ESC+~B
Hex code
ESC
~B
Parameter
<1B>16
<7E>
16
<42>
16
None
Default setting
None
Persistence of
the command
When printer is powered off
Set command will not be retained.
Validity in a job
Becomes invalid after execution
Validity after a job
Becomes invalid after the job
[Function]
Specifies eject and cut operation
[Format]
<~B>
[Coding Example]
<A>
<~B>
<Z>
[Notes]
1. Valid only for cutter models.
2. This command is used to cut the last label remaining in the printer.
3. This command <~B> should be used by differentiating between Start code<A> and Stop code<Z>.
4. This command <~B> may not be used in combination with other commands.
5. This command <~B> is valid when the printer still holds the label which has not been cut after being printed.
[Tips]
1. This command is used to cut remaining label in the printer after the commands <~A>0 or <~>0 is executed.
(2)
(1) Label stop position
A: Printed
B: Not printed
C: Not printed
D: Not printed
(2) Command received
(3) Label is fed to the cut position.
(4) Label is cut off.
(5) Label is back fed to the print position.
A
B
C
Cut position
Print head
A
B
C
D
B
C
D
B
C
D
(1)
(3)
(4)
(5)
Label feed direction
Eject and Cut