195
[Notes]
1． Place this command between start code <A> and stop code <Z>. If specifying this command in the item with print data, this command will
be ignored.
2． When setting the label feed direction in the reverse direction, make sure the label feed length does not become too long. The print data may
appear overlapped with each other or the printer may wrongly detect a paper end error because of the label coming off the platen. Also,
there is a possibility that the label would come off the platen in the same way if feeding the label to the tear off position or to the cutter
position in the reverse direction.
3． Do not feed the label backward right after cutting the label in cutter mode or dispensing the label in dispenser mode.
4． When omitting the feed distance in the forward direction, label feeding motion will be exactly the same as when pressing the key in offline
state.
5． Label feeding motion specified with this command will be performed in online state.
6． Omitting the feed distance in the reverse direction may result in command error and the label will not be fed.
7． When the sensor is disabled in continuous mode, the label cannot be fed by <IK>0 (feed distance omitted).
8． Specifying the feed length outside the valid range may result in command error and the label will not be fed.
[Valid range]
To Next Page
Loading...
