102
[Coding Example] Error correction level: 7％, Size of one side of cell: 05
Data setting mode: manual, Concatenation mode: Normal
<A>
<V>100<H>200<2D30>,L,05,0,0
<DS>1,012345
<Q>2
<Z>
[Notes]
1. In case any other parameters than above are specified, or parameters and quantity of data are not consistent with each other,
the symbol will not be printed correctly.
2. Note that data part use two different commands <DS> and <DN> according to input mode.
Auto setting (Data setting mode)
<DN>mmmm,n~n
[Tips 1]
1. When Kanji is to be specified, quantity of data shall be twice as many as number of total Kanji characters.
2. The address 80H~9FH, E0H~FFH cannot be used for binary data input, since these characters are only handled in Kanji
mode.
Binary input in manual data setting mode
<DN>mmmm,n~n
Other input mode
<DS>1,n~n (Numeric)
<DS>2,n~n (Alphanumeric)
<DS>3,n~n (Kanji)
Mixture of different data input mode
Different data input mode can be used in the same command string. See example below.
<A>
<V>100<H>100
<2D30>,a,bb,c,d
<DS>3,n~n
<DN>mmmm,n~n
<DS>1,n~n
<Q>1
<Z>
[Tips 2]
1. Data part shall follow directly symbol format part , or a data part and other data part shall follow successively without interval.
Otherwise printed result may be incorrect.
2. Quantity of data shall no exceed the maximum 7000 bytes. Also the maximum number of data block, which can be used in one
symbol is 200.
To Next Page
Loading...
