SATO WS4 Series - Set Up LAN Connection

69
[Coding example 2] Barcode type: ITF, Narrow bar width: 04, Barcode height: 240, Print data: 98002345678163
<A>
<V>100<H>100
<BD>20424098002345678163
<Q>2
<Z>
[Coding example 3] Barcode type: UPC-A, Narrow bar width: 02, Barcode height: 120, Print data: 20123948573
<A>
<V>240<H>100
<BD>H0212020123948573
<Q>2
<Z>
[Notes]
1. For CODABAR (NW-7), CODE39, Industrial 2of5 and Matrix 2of5, the inter-character pitch of the barcode can be specified.
The barcode inter-character pitch is set by specifying the character pitch <P> immediately before.
If not set, the inter-character pitch will be of the same size as a space command.
Example) Inter-letter pitch (Not specified / 0 / 2) x Narrow bar width (2 dots) = Inter-character pitch (4 dots)
Inter-letter pitch (1) x Narrow bar width (3 dots) = Inter-character pitch (3 dots)
Inter-letter pitch (3) x Narrow bar width (3 dots) = Inter-character pitch (9 dots)
2. HRI text of JAN/EAN8, JAN/EAN13, UPC-A will be printed properly in following conditions.
8 dots/mm (203dpi) - Narrow bar width: [02], [03]
12 dots/mm (305dpi) - Narrow bar width: [03], [04]
[Tips]
1. When the value other than valid range is set, command error will occur and barcode will not be printed.
2. Increasing narrow bar width may exceed the print area.
3. Scanner may not read the barcode with valid character pitch when the Character Pitch <P> command is increased.
Also, increasing the narrow bar width may cause the same type of problem. For more information, refer to the documentation of
your scanner.
4. For specifying the narrow bar width, consider the reading compatibility of scanner beforehand.
5. Adjust the Print Speed <CS> or Print Darkness <#E> commands in case of scanner reading problem.
6. If Start/Stop characters are not included in print data in the specification of CODABAR(NW-7) or CODE39, barcode will be printed;
however, scanner can not read it.
7. If sending the print data including check digit in the specification of JAN/EAN-13 or JAN/EAN-8, set the correct calculated value.
Barcode will be printed even when the data includes improper check digit; however, scanner can not read it.