SICK DL100 Pro

8024484/2019-06-06 • © SICK AG • Subject to change without notice 63
Operation via Ethernet (Ethernet interface)
“Measuredvalues”eld
Parameters Description
Distance “Distance”measuredvalueafterltering,correctionsand
oset
Read/write access
• Read only
Unit
• m
Speed “Speed” measured value
Read/write access
• Read only
Unit
• m/s
Acceleration “Acceleration” measured value
Read/write access
• Read only
Unit
• m/s
2
Table 34: “Measurement data” page – “Measured values” eld
9.2.4 Diagnostics data
Field Description
Status Display of device status: Ready for operation, warning(s)
active, error active, laser switched on, MF1 active and MF2
active
Read/write access
• Read only
Warnings Display of current warnings: Laser, temperature, level and
plausibility
Read/write access
• Read only
Fault Display of current errors: Laser, temperature, level and plausi-
bility
Read/write access
• Read only
Received signal
level
Display of the current received signal level (attenuation value)
Read/write access
• Read only