SICK DL100 Pro

8024484/2019-06-06 • © SICK AG • Subject to change without notice 59
Operating the measuring device
“SpecFu” menu
(cont.)
Parameters Description
FMode Requirement for display
• Only for DL100-xxxBxxxx variants with frequency changeover
Select the frequency range. Frequency changeover may
be necessary in cases of multiple distance measuring
devices being arranged in parallel. → See also Page 28,
Chapter 6.4.
Options
• Mode 1
• Mode 2
• Mode 3
Factory setting
• Mode 1
Reset
Perform a reset.
→ See Page 59, Chapter 8.6.
Table 25: “SpecFu” menu
8.6 Performing a reset
1. Select the “Reset” parameter in the “SpecFu” menu.
→ See Page 57, Chapter 8.5.15.
2. Press the
pushbutton.
3. Theconrmationprompt“Sure?”appears.
4. Press the
pushbutton to reset the measuring device to its initial
state. Press the pushbutton to cancel the process.