SICK DL100 Pro

Operating the measuring device
42 © SICK AG • Subject to change without notice • 8024484/2019-06-06
7.4.3 SSI connection diagram
Tx+
Tx–
Rx+
Rx–
1
2
4
grn
gra
yel
pnk
3
FE n.c.
5
brn
1
2
5
4
3
Fig. 25: SSI connection diagram, M12 male connector, 5-pin, B-coded
Contact Labeling Wire color Description
1 Tx+ yellow Data signal, not inverted
2 Tx– Green Data signal, inverted
3 Rx+ Gray Clock, not inverted
4 Rx– Pink Clock, inverted
5 FE n.c. brown –
Table 9: SSI male connector description
8 Operating the measuring device
Damage to the controls
WARNING!
Pushbutton damage due to improper handling!
Improper handling of the pushbuttons can damage them.
Thiswillmakeoperationdicultorimpossible.
For this reason:
• Onlyoperatethepushbuttonswithyourngersora
suitable pointing device.
• Do not operate the pushbuttons using sharp or hard
objects.
NOTE!
Once the device is integrated into a PROFINET network,
the parameters entered in the measuring device are
overwritten.
8.1 Measured value display
Once the measuring device is supplied with power, the current measured
value is shown on the display.