176 FLOWSIC100 Flare-XT · Operating Instructions · 8023761/V 1-0/2020-10 · © SICK Engineering GmbH
Annex
15 .1
Compliances
15.1.1 Compliances of FLSE100-XT sender/receiver units
15.1.1.1 CE declaration
The FLSE100-XT sender/receiver units have been developed, built and tested according to
the following EU Directives:
● ATEX Directive 2014/34/EU
● EMC Directive 2014/30/EC
Conformity with the above Directives has been determined and the CE label attached to the
device.
15.1.1.2 Standards compatibility and type approval
The FLSE100-XT sender/receiver units comply with the following Norms, Standards or
recommendations:
● IEC 60079-0: 2015, IEC 60079-1: 2014, IEC 60079-7: 2015,
● IEC 60079-11: 2011 + Cor. 2012, IEC 60079-15: 2010, IEC 60079-26: 2014,
● IEC 61010-1: 2010 + Corr. 2011 and comparable European Standards and comparable
ANSI/UL or CSA Standards
● EN 60079-0:2012, EN 60079-1:2014, EN 60079-7:2015, EN 60079-11:2012,
EN60079-15:2010
● EN 60079-26:2015, EN 60079-28:2015, EN 61326-1:2013
● EN 61010-1 (Safety requirements for electrical equipment)
● EN 60529: 1991/A1:2000/A2:2013 (IP)
15.1.2 Compliances of Interface Unit
15.1.2.1 CE declaration
The Interface Unit has been developed, manufactured and tested in accordance with the
following EU Directives:
● ATEX Directive 2014/34/EU
● EMC Directive 2014/30/EC
Conformity with the above Directives has been determined and the CE label attached to the
device.
NOTICE:
Applied European standards and harmonized standards are listed in the valid
version of the manufacturer‘s CE conformity declaration.
To Next Page
Loading...
