100 FLOWSIC100 Flare-XT · Operating Instructions · 8023761/V 1-0/2020-10 · © SICK Engineering GmbH
Installation Interface Unit
6.4.5
Fitting the weatherproof cover
6.4.5.1 Weatherproof cover for Interface Unit for wall fitting
Fig. 55 Dimensions [mm]
1 First screw the weatherproof cover to the wall through the two holes marked in
→ Fig. 56.
Fig. 56 Fitting the weatherproof cover on the wall
2 Then screw the Interface Unit also to the wall through the four holes in the weatherproof
cover as marked in → Fig. 57.
NOTICE:
The weatherproof cover for wall fitting (Part No. 2108970) is delivered without
fastening material.
▸
Use suitable fastening material to fit the weatherproof cover on the wall.
▸
Observe the total weight of the Interface Unit together with the weather-
proof cover as well as local and legal regulations for the design of the wall
construction and fastening material. Weight of Interface Unit and weather-
proof cover, see Technical Data
p. 158, §12.3.
447
448
554
To Next Page
Loading...
