SICK FLOWSIC100 Flare-XT

70 FLOWSIC100 Flare-XT · Operating Instructions · 8023761/V 1-0/2020-10 · © SICK Engineering GmbH
Installation FLSE100-XT
9 The self-cutting ring remains in the fixed position on the duct probe.
10 Then tighten the pipe screw fitting again hand-tight.
WARNING: Leakage hazard
Repeated use may damage the gasket of the pipe screw fitting.
▸ Before reuse, i.e. whenever the pipe screw fitting is to be tightened again,
check the gasket of the pipe screw fitting:
▸ Replace the gasket if it has visible deformations, indentations or damage. In
this case contact SICK Service.
Otherwise there is a risk of leakage.