SICK FLOWSIC100 Flare-XT

88 FLOWSIC100 Flare-XT · Operating Instructions · 8023761/V 1-0/2020-10 · © SICK Engineering GmbH
Installation Interface Unit
▸ Observe all safety information.
▸ If anything is not clear: Please contact SICK Customer Service.
Designated users
All operators of the Interface Unit should be specifically trained on this device,
knowledgeable of relevant regulations, and able to assess potential hazards related to its
operation. Skilled persons are persons according to DIN VDE 0105, DIN VDE 1000-10 or
IEC 60050-826 or directly comparable standards.
The named persons must have exact knowledge of operational hazards caused, e.g., by low
voltage, hot, toxic, explosive gases or gases under pressure, gas-liquid mixtures or other
media as well as adequate knowledge of the measuring system gained through training.
Specific requirements for the use of devices in hazardous areas
▸ Cabling/installation, device setup, maintenance and testing may only be
carried out by experienced persons familiar with the rules and regulations
for hazardous areas, in particular:
– Degree of protection
– Fitting instructions
– Area definition
▸ Regulations to be applied:
– IEC 60079-14
– IEC 60079-17
or comparable national regulations.