7SR11 & 7SR12 Settings & Instruments Guide
©2017 Siemens Protection Devices Limited Chapter 2 Page 19 of 20
2.1.5 Connecting to the Relay for setting via Reydisp
When Reydisp software is running all available communication ports will automatically be detected.
On the start page tool bar open up the sub-menu ‘File’ and select ‘Connect’.
The ‘Connection Manager’ window will display all available communication ports. With the preferred port
highlighted select the ‘Properties’ option and ensure the baud rate and parity match that selected in the relay
settings. Select ‘Connect’ to initiate the relay-PC connection.
Figure 2.1-4 PC Comm Port Selection
The relay settings can now be configured using the Reydisp software. Please refer to the Reydisp Evolution
Manual for further guidance.
To Next Page
Loading...
