FS20 Marine Fire Detection Control Panel
Siemens Industry, Inc. A6V10519176_enUS_b
Building Technologies Division
Assembly, Installation, Commissioning and Maintenance
If additional tools are required, such as a ladder, they must be safe and used as intended.
When starting the fire control panel ensure that unstable conditions cannot arise.
Ensure that all points listed in the 'Testing the Product Operability' section are observed.
Only set controls to normal function when the product operability is completely tested and the
system is handed to the customer.
Testing the Product Operability
Prevent the remote transmission from triggering inappropriately.
If testing building installations or activating devices from third-party companies, you must
collaborate with the appointed people.
The activation of fire control installations for test purposes must not cause injury to anyone or
damage to the building installations. The following instructions must be observed:
– Use the correct potential for activation; this is generally the potential of the building
installation.
– Only check controls up to the interface (relay with blocking option).
– Make sure that only the controls to be tested are activated.
Inform people before testing the alarm devices and allow for possible panic responses.
Inform people about any noise or mist being produced.
Before testing the remote transmission, inform the people that will receive the corresponding
alarms.
Modifications to the System Layout and Products
Modifications to the system and to individual products may lead to troubles, malfunctioning and
safety risks. Written confirmation must be obtained from Siemens and the corresponding safety
people for modifications or additions.
Modules and Spare Parts
Components and spare parts must comply with the technical specifications defined by Siemens.
Only use products specified or recommended by Siemens.
Only use fuses with the specified fuse characteristics.
Wrong battery types and improper battery changing lead to a risk of explosion. Only use the
same battery type or an equivalent battery type recommended by Siemens.
Batteries must be disposed of in an environmentally friendly manner. Observe national
guidelines and regulations.
To Next Page
Loading...
Need help?
General
