Result
The faceplate for parameter data export is opened.
Additional information
For additional information, refer to the following sections:
6.4.8.2 Faceplate
Introduction
The faceplate includes various filter criteria and export settings for exporting parameter data.
The export can be started, or an active export operation can be canceled.
When you open the faceplate, you will see an overview of the last executed or active export
job.
If an export job is active, you cannot change any filter settings. You can only cancel the export
job.
Automatic synchronization can always be enabled or disabled.
The following figure shows an example of the faceplate for the parameter data export.
Operator control and monitoring
6.4 Functions in the overview screen
Maintenance Station
104 Function Manual, 03/2016, A5E36187641-AA
To Next Page
Loading...
