5.11.1.4 Configuring maintenance information
Introduction
In PCS 7 V8.2 and higher, user-specific maintenance information texts can be configured in
the process control for displaying detailed diagnostic information in the faceplate.
Sixteen information objects are created automatically by the system.
Automatically created information objects are:
● External service request, no additional information
● Service interval reached
● Different operating state
● Different performance parameters
● Auxiliary energy problem
● Auxiliary material problem
● Mechanical problem
● Electrical problem
● Pneumatic problem
● Calibration request
● Measuring circuit check
● Process-related event
● Cleaning request
● Emptying request
● Wear reserve undershot
● Degree of pollution high
Texts for the automatically created maintenance information are available in multiple
languages.
You can find information on this in the
Process Control System PCS 7; Operator Station
configuration manual, section "Setting languages"
An information object has the properties "Name:" and "Name for user:".
The name of the maintenance information is entered in the "Name:" entry field.
The name that is displayed in the faceplate is entered in the "Name for user:" entry field.
You can change the properties of information objects.
You can restore the diagnostic settings for all lists in the tab using the "Set Default Settings"
button.
Note
This function is available if you configured the Maintenance Station in the MS Standard version.
Configuring the maintenance stations
5.11 Advanced diagnostics settings
Maintenance Station
Function Manual, 03/2016, A5E36187641-AA 61
To Next Page
Loading...
Need help?
General
