Requirement
The Maintenance Station has been created.
Procedure
The following section describes how to configure, change and delete a target object.
To open the "Advanced Diagnostics Settings" dialog, follow the steps below.
1. Open the plant view in the SIMATIC Manager.
2. Select the object in the tree view:
– If you are using a multiproject, select the object "[name of the project] MP".
– If you are using a single project, select the object "[name of the project]".
3. Select the menu command Options > Plant Hierarchy > Advanced Diagnostics Settings... .
The "Advanced Diagnostics Settings" dialog box opens.
4. Select the "Functions for maintenance" tab
Configuring the maintenance target
1. Click "Add..." in the "Maintenance targets" area.
The "Add maintenance target" dialog box opens.
2. Enter the name for the target object in the "Name" entry field.
3. Click "Browse".
4. Select the required target directory.
The target directory is entered in the "Path:" entry field.
5. Click "OK".
The "Add maintenance targets" dialog box closes.
6. Click "OK".
The "Advanced Diagnostics Settings" dialog box closes.
Changing maintenance target properties
1. In the "Maintenance targets" area, select the target object whose properties you want to
change.
2. Click "Properties...".
The "Properties maintenance target" dialog box opens.
3. Make the desired changes.
4. Click "OK".
The "Properties maintenance target" dialog box
closes.
5. Click "OK".
The "Advanced Diagnostics Settings" dialog box closes.
Configuring the maintenance stations
5.11 Advanced diagnostics settings
Maintenance Station
Function Manual, 03/2016, A5E36187641-AA 57
To Next Page
Loading...
Need help?
General
