● TCP/IP, UDP, http ... (standard Ethernet services)
● For mixed operation of IRT and RT it has to be observed that the IRT-compatible devices
must form an IRT domain, i.e. there must not be any non-IRT devices on the data
transmission link between the IRT devices.
Additional references
Please refer to the following documents on this subject
● SIMOTION D4x5 Commissioning and Hardware Installation Manual
● SIMOTION D4x5-2 Commissioning and Hardware Installation Manual
● SIMOTION D410 Commissioning Manual
● SIMOTION D410-2 Commissioning and Hardware Installation Manual
● SIMOTION P320-4 E / P320-4 S Commissioning and Hardware Installation Manual
● SIMOTION C Operating Instructions
● SIMOTION Communication System Manual
and the SIMOTION SCOUT online help.
6.4.4 Inserting a drive
6.4.4.1 Drives with SIMOTION
Note the following:
Drives must be differentiated between:
● Drives that are connected to PROFIBUS/PROFINET
● Drives that are connected directly to the SIMOTION device
Configuring/parameterizing
6.4 Configuring devices
SIMOTION SCOUT
88 Configuration Manual, 11/2016
To Next Page
Loading...
