Siemens SIMOTION SCOUT User Manual

For all other drives or for third-party drives, the appropriate commissioning program for the
specific drive must be used. If required, you must commission these drives directly on the drive.
Table 6-2 Commissioning of various drives
Drive Connection Commissioning
SINAMICS S110, S120,
S150,
G110 CPM100, G120, G130,
G150, GM150
PROFIBUS DP or analog
interface
With SIMOTION SCOUT or
STARTER
SINAMICS S120 PROFINET With SIMOTION SCOUT or
STARTER
MICROMASTER 410 analog interface With SIMOTION SCOUT or
DRIVE ES Basic or
STARTER
MICROMASTER
420/430/440
PROFIBUS DP or
analog interface
With SIMOTION SCOUT or
DRIVE ES Basic or
STARTER
COMBIMASTER 411 PROFIBUS DP or
analog interface
With SIMOTION SCOUT or
DRIVE ES Basic or
STARTER
SIMODRIVE 611U PROFIBUS DP or analog
interface
With SIMOCOM U or
DRIVE ES Basic
MASTERDRIVES MC, VC PROFIBUS DP or analog
interface
With SIMOVIS or
DRIVE ES Basic
SIMODRIVE POSMO
CA; CD, SI
PROFIBUS DP With SIMOCOM U or
DRIVE ES Basic
Third-party drives Analog interface or
PROFIBUS DP accord‐
ing to PROFIdrive profile
V3.02
With commissioning tool supplied by the
manufacturer
Note
If the Drive-ES Basic commissioning program is installed, it can be called by SIMOTION
SCOUT in the project navigator via Commissioning.
6.4.4.5 SINAMICS S120 on SIMOTION
STARTER functionality in SIMOTION SCOUT
It is possible to parameterize drives directly with SIMOTION SCOUT. The following example
describes how to insert a SINAMICS drive in SIMOTION SCOUT.
Configuring/parameterizing
6.4 Configuring devices
SIMOTION SCOUT
92 Configuration Manual, 11/2016

Siemens SIMOTION SCOUT Specifications

General

Brand	Siemens
Model	SIMOTION SCOUT
Category	Control Unit
Language	English