Programming and Operating Manual (Milling)
6FC5398-4DP10-0BA1, 01/2014
175
Programming example 2: Milling around a closed contour externally
With this program, the same contour is milled as in example 1. The difference is that the contour programming is now in the
calling program.
; T3: Milling cutter with radius 7
; Program feedrate and spindle speed
N30 G17 G0 G90 X100 Y200 Z250 G94
; Approach start position
N40 CYCLE72 ( "PIECE245:PI
ECE245E", 250, 200, 3, 175, 10,1,
1.5, 800, 400, 11, 41, 2, 20, 1000, 2, 20)
; Cycle call
Proceed through the following steps:
1. Select the desired operating area.
2. Open the vertical softkey bar for available milling cycles.
3. Press this softkey to open the window for CYCLE72. Enter a name in the first input field.
To Next Page
Loading...
