Programming and Operating Manual (Milling)
6FC5398-4DP10-0BA1, 01/2014
31
The SINUMERIK 808D ADVANCED control system can store a maximum of 300 part programs which include those created
by the control system for certain functions such as MM+, TSM, and so on.
Pressing this key on the PPU allows you to open the following window:
①
Stores the NC programs for subsequent operations
⑨
Executes the selected file. No editing is allowed in the
execution process.
②
Manages and transfers the manufacturer cycles
⑩
Creates new files or directories
③
Reads in/out files via the USB drive and executes the
program from the external storage media
⑪
Searches for files
④
Reads in/out files via the RS232 interface and
executes the program from the external PC/PG
⑫
Selects all files for the subsequent operations
⑤
Reads in/out files via the Ethernet interface and
executes the program from an external PC/PG
⑬
Copies the selected file(s) to the clipboard
⑥
Backs up manufacturer files
⑭
Pastes the selected file(s) from the clipboard to the
current directory
⑦
Backs up user files
⑮
Restores the deleted file(s)
⑧
Shows the recently accessed files
⑯
Opens the second-level softkeys, for example:
To Next Page
Loading...
Need help?
General
