Programming and Operating Manual (Milling)
6FC5398-4DP10-0BA1, 01/2014
209
Explanation of the parameters
For an explanation of the parameters RTP, RFP, SDIS, DP, and DPR, refer to Section "Drilling, centering - CYCLE81
(Page 126) ".
DIATH, KDIAM, and PIT (nominal diameter, core diameter, and thread pitch)
These parameters are used to determine the thread data nominal diameter, core diameter, and pitch. The parameter DIATH
is the external, and KDIAM is the internal diameter of the thread. The travel-in/travel-out movements are created internally in
the cycle, based on these parameters.
The value of the parameter FFR is specified as the current feedrate value for thread milling. It is effective when thread
milling on a helical path.
This value will be reduced in the cycle for the travel-in/travel-out movements. The retraction is performed outside the helix
path using G0.
CDIR (direction of rotation)
This parameter is used to specify the value for the machining direction of the thread.
If the parameter has an illegal value, the following message will appear:
"Wrong milling direction; G3 is generated".
In this case, the cycle is continued and G3 is automatically generated.
The parameter TYPTH is used to define whether you want to machine an external or an internal thread.
CPA and CPO (center point)
These parameters are used to define the center point of the drill hole or of the spigot on which the thread will be produced.
Note
The cutter radius is calculated internally in the cycle. Therefore, a tool compensation must be programmed before calling the
cycle. Otherwise, the alarm 61000 "No tool compensation active" appears and the cycle is aborted.
If the tool radius=0 or negative, the cycle is also aborted and this alarm is issued.
With internal threads, the tool radius is monitored and alarm 61105 "Cutter radius too large" is output, and the cycle is
aborted.
Programming example: Internal thread
By using this program, you can mill an internal thread at point X60 Y50 of the G17 plane.
See the following programming example for internal thread:
To Next Page
Loading...
Need help?
General
