Programming and Operating Manual (Milling)
34 6FC5398-4DP10-0BA1, 01/2014
Proceed through the following steps to search for a block:
1. Press this softkey in the opened program editor window.
2. Press this softkey to search via text. Alternatively, you can search with a given line number by
pressing the following softkey:
3. Enter the search text or line number in the input field. Press this key to select a starting point for
search if you choose to search via text.
4. Press this softkey to start the search, or otherwise, press the following softkey to cancel the search:
Copying, cutting, and pasting blocks
Proceed through the following steps to copy, cut, and paste blocks:
1. Press this softkey in the opened program editor window to insert a marker.
2 Use the cursor keys to select the desired program blocks.
3. Press the following softkey to copy the selection to the buffer memory:
Press the following key to cut the selection to the buffer memory:
4. Place the cursor on the desired insertion point in the program and press this softkey.
The data is successfully pasted.
To Next Page
Loading...
