Siemens SIPROTEC 7SJ80

Default Display
A number of pre-defined measured value pages are available depending on the device type. The start page of
the default display appearing after startup of the device can be selected in the device data via parameter 640
Start image DD auswählen.
for the 6-line Display of 7SJ80
[grundbild6zei-mit-u-ohne-erw-mw-20070116, 1, en_US]
Figure E-1
Default display of the 7SJ80 for models with V without extended measured values
E.5
Default Settings and Protocol-dependent Functions
E.5 Default Display
SIPROTEC 4, 7SJ80, Manual 465
E50417-G1140-C343-A8, Edition 12.2017